收藏本站
LTC3219
OPERATION
Power Management
The LTC3219 uses a switched capacitor charge pump to
boost CPO to as much as 2 times the input voltage up to
5.04V. The part starts up in 1x mode. In this mode V BAT is
connected directly to CPO. This mode provides maximum
ef?ciency and minimum noise. The LTC3219 will remain in
1x mode until an LED current source drops out. Dropout
Charge Pump Strength
When the LTC3219 operates in either 1.5x mode or 2x mode,
the charge pump can be modeled as a Thevenin-equivalent
circuit to determine the amount of current available from
the effective input voltage and effective open-loop output
resistance, R OL (Figure 1).
occurs when a current source voltage becomes too low
for the programmed current to be supplied. When drop-
R OL
+
out is detected, the LTC3219 will switch into 1.5x mode.
The CPO voltage will then start to increase and attempt
to reach 1.5x V BAT , up to 4.53V. Any subsequent dropout
+
–
1.5V BAT OR 2V BAT
3219 F01
CPO
–
will cause the part to enter the 2x mode. The CPO voltage
will attempt to reach 2x V BAT , up to 5.04V.
A 2-phase non-overlapping clock activates the charge
pump switches. In the 2x mode, the ?ying capacitors are
charged on alternate clock phases from V BAT to minimize
CPO voltage ripple. In 1.5x mode, the ?ying capacitors are
charged in series during the ?rst clock phase and stacked
in parallel on V BAT during the second phase. This sequence
of charging and discharging the ?ying capacitors continues
at a constant frequency of 850kHz.
The current delivered by each LED current source is con-
trolled by an associated DAC. Each DAC is programmed
via the I 2 C port.
Soft-Start
Initially, when the part is in shutdown, a weak switch
Figure 1. Equivalent Open-Loop
R OL is dependent on a number of factors including the
switching term, 1/(2f OSC ? C FLY ), internal switch resistances
and the non-overlap period of the switching circuit. How-
ever, for a given R OL , the amount of current available is
directly proportional to the advantage voltage of 1.5V BAT
– CPO for 1.5x mode and 2V BAT – CPO for 2x mode. Con-
sider the example of driving LEDs from a 3.1V supply. If
the LED forward voltage is 3.8V and the current sources
require 100mV, the advantage voltage for 1.5x mode is
3.1V ?1.5 – 3.8V – 0.1V or 750mV. Notice that if the input
voltage is raised to 3.2V, the advantage voltage jumps to
900mV, a 20% improvement in available strength.
From Figure 1, for 1.5x mode the available current is
given by:
1 . 5 V BAT CPO
connects V BAT to CPO. This allows V BAT to slowly charge
the CPO output capacitor and to prevent large charging
currents from occurring.
I OUT =
– V
R OL
(1)
The LTC3219 also employs a soft-start feature on its
For 2x mode, the available current is given by:
2 V BAT CPO
charge pump to prevent excessive inrush current and
supply droop when switching into the step-up modes. The
current available to the CPO pin is increased linearly over
I OUT =
– V
R OL
(2)
a typical period of 125μs. Soft-start occurs at the start of
both 1.5x and 2x mode changes.
Notice that the advantage voltage in this case is 3.1V ?
2 – 3.8V – 0.1V = 2.3V. R OL is higher in 2x mode but a sig-
ni?cant overall increase in available current is achieved.
3219fa
8
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LTC3220EPF#PBF IC LED DRVR QVGA DISPLAY 28UTQFN
LTC3230EUD#PBF IC LED DRIVR WHITE BCKLGT 20-QFN
LTC3452EUF#TRPBF IC LED DRIVER PHOTO FLASH 20-QFN
LTC3453EUF#TRPBF IC LED DRIVER PHOTO FLASH 16-QFN
LTC3454EDD#TRPBF IC LED DRIVER PHOTO FLASH 10-DFN
LTC3490EDD#PBF IC LED DRIVER PHOTO FLASH 8-DFN
LTC3783EFE#PBF IC LED DRVR PWM CONTROL 16-TSSOP
LV5026MC-AH IC LED DRIVER 1CH HV 10SOIC
相关代理商/技术参数
LTC3219EUD#TRPBF 功能描述:IC LED DRIVR QVGA DISPLAY 20-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3219EUD-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:250mA Universal Nine Channel LED Driver
LTC3219EUD-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:250mA Universal Nine Channel LED Driver
LTC3220 制造商:LINER 制造商全称:Linear Technology 功能描述:360mA Universal 18-Channel LED Driver
LTC3220_1 制造商:LINER 制造商全称:Linear Technology 功能描述:360mA Universal 18-Channel LED Driver
LTC3220-1 制造商:LINER 制造商全称:Linear Technology 功能描述:360mA Universal 18-Channel LED Driver
LTC3220EPF#PBF 功能描述:IC LED DRVR QVGA DISPLAY 28UTQFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:60 系列:- 恒定电流:- 恒定电压:- 拓扑:线性（LDO），PWM，升压（升压） 输出数:8 内部驱动器:是 类型 - 主要:背光 类型 - 次要:RGB，白色 LED 频率:500kHz ~ 1.5MHz 电源电压:4.75 V ~ 26 V 输出电压:45V 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:* 工作温度:-40°C ~ 85°C
LTC3220EPF#TRPBF 功能描述:IC LED DRVR QVGA DISPLAY 28UTQFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND